6S5-G5332-00-00 Bearing Housing for Yamaha FZR 1800 2009-2016

Bearing Housing for Yamaha FZR 1800

This bearing housing for Yamaha FZR 1800 watercraft supports the driveshaft bearing assembly and carries OEM cross-reference 6S5-G5332-00-00 for direct replacement.

Overview

This bearing housing is a replacement driveline component for Yamaha FZR 1800 personal watercraft, built to hold and align the driveshaft bearing under load. It keeps the shaft spinning true so vibration stays low and bearing life stays long. A solid choice for riders doing their own maintenance and for shops servicing FZR 1800 machines.

Built For Performance

• Cast housing shaped to match the OEM mounting points and bore
• Holds the driveshaft bearing in correct alignment
• Seals against water and grit intrusion at the through-hull area
• Rated for the sustained high RPM loads of the FZR 1800 engine
• Direct fit replacement for OEM 6S5-G5332-00-00

Fits These Machines

• for Yamaha FZR 1800, 2009-2016

On-The-Job Use

• Driveline repairs after bearing wear or water intrusion
• Routine maintenance on high-hour FZR 1800 craft
• Rebuilds where the original housing is corroded or cracked
• Shop service on customer Yamaha 1800 series skis

Specs At A Glance

Good To Know

Q: Does this housing come with the bearing installed? A: It is listed as the housing only, so reuse your existing bearing or fit a new one during install. Check the bore and seating surface before assembly.

Q: Will it fit every FZR 1800 built between 2009 and 2016? A: It is listed for that year range, but Yamaha sometimes changes driveline parts mid-run. Confirm your machine's serial number against the part number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.