6S8-81960-00-00 Voltage Regulator for Yamaha V1 1050 2016

Voltage Regulator for Yamaha V1 1050

This voltage regulator replaces OEM part 6S8-81960-00-00, controlling charging output on a Yamaha V1 1050 so the battery stays charged and the electrical system runs at a stable voltage.

Overview

This voltage regulator for Yamaha is built to replace the factory unit on the V1 1050, keeping charging voltage within spec so the battery, ignition, and lighting circuits all get steady power. It cross-references OEM part 6S8-81960-00-00, making it a direct-fit replacement for a failed or weak regulator. Riders and mechanics doing their own repairs will find this voltage regulator for Yamaha a straightforward swap when charging symptoms show up.

Built For Performance

• Direct replacement for OEM part 6S8-81960-00-00
• Regulates charging output to protect the battery from overcharging
• Solid-state construction with no moving parts to wear out
• Sealed housing resists moisture and vibration
• Pre-drilled mounting points match the factory location
• Connector and terminal layout matches the original unit

Fits These Machines

• for Yamaha V1 1050 (2016)

On-The-Job Use

• Restoring charging on a V1 1050 that will not hold battery voltage
• Replacing a regulator that has failed and left the battery flat
• Routine electrical maintenance when charging output drifts out of spec

Specs At A Glance

Good To Know

Q: How do I know the regulator is the problem and not the battery? A: A failed regulator usually shows up as a battery that will not stay charged or voltage that climbs too high while running. Test charging output at the battery terminals before replacing parts.

Q: Does this regulator need any programming or setup? A: No, it is a plug-in replacement with no programming required. Confirm the connector matches your harness before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.