6x FJ1267 Fuel Injector Set For 2014-2017 Jeep Cherokee 3.2L V6 Gas 4627794AA

Fuel Injector Set for 2014-2017 Jeep Cherokee 3.2L V6

The 6-piece fuel injector set replaces worn or clogged injectors on 2014-2017 Jeep Cherokee 3.2L V6 gas engines, restoring fuel delivery and performance (OEM cross-ref: 4627794AA, FJ1267).

Overview

This fuel injector set includes six direct-fit injectors engineered for the 2014–2017 Jeep Cherokee 3.2L V6 gas engine. The fuel injector set replaces factory injectors that are leaking, clogged, or causing misfire codes, returning stable idle and fuel economy. Technicians and home wrenchers rely on this fuel injector set for a straightforward, plug-and-play install that meets OE flow and spray-pattern specs.

Built For Performance

• Precisely calibrated flow rates match stock 3.2L V6 fuel trims
• Multi-hole nozzle design yields fine atomization for clean combustion
• Upgraded internal coil improves cold-start and warm-hot responsiveness
• Pre-installed O-rings sized to the original manifold and rail bore
• Corrosion-resistant stainless-steel body and pintle for long service life
• 100% flow tested and leak checked to meet OE leak-down standards

Fits These Machines

• for 2014 Jeep Cherokee 3.2L V6
• for 2015 Jeep Cherokee 3.2L V6
• for 2016 Jeep Cherokee 3.2L V6
• for 2017 Jeep Cherokee 3.2L V6

On-The-Job Use

• Replacing leaking or clogged fuel injectors to cure rough idle
• Eliminating P0201–P0206 injector circuit or misfire DTCs
• Restoring throttle response and fuel mileage after high-mileage wear
• Preventive engine tune-up during intake manifold or fuel rail service
• Swapping in fresh injectors when upgrading the fuel system on a 3.2L V6

Specs At A Glance

Good To Know

Q: Do I need to replace the fuel injector seals when installing this set? A: It is recommended to always install new O-rings and seals to prevent fuel leaks; this set may include pre-installed seals—verify before installation.

Q: Can a single injector be replaced instead of the full set? A: While possible, replacing all six injectors ensures balanced fuel delivery and prevents future failures on the remaining old injectors.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.