6x UF486 Ignition Coil Pack & Spark Plug Set For Ford Fusion Escape Mercury 3.0L

6x UF486 Ignition Coil Pack & Spark Plug Set for Ford Fusion Escape Mercury 3.0L

This 6-piece UF486 ignition coil pack and spark plug set delivers dependable spark for Ford Fusion, Escape, and Mercury 3.0L V6 engines, replacing OEM references including UF486, DG526, and 5C1089.

Overview

The 6x UF486 ignition coil pack and spark plug set includes six coils and six plugs to replace worn ignition components on Ford Fusion, Escape, and Mercury models with the 3.0L Duratec V6. This ignition coil pack & spark plug set helps restore fuel efficiency, smooth idle, and quick starts while eliminating misfire trouble codes. Built for high-mileage drivers and service pros, the set addresses common power loss and rough running on those 3.0L Ford and Mercury engines.

Built For Performance

• Epoxy-molded coil bodies resist vibration and extreme underhood heat
• Platinum-tipped spark plugs deliver extended service life and cleaner combustion
• OE-style electrical connectors and silicone boots ensure a snap-on, no-cut fit
• Pre-gapped plugs eliminate on-the-fly adjustment so installation is faster
• Corrosion-resistant terminals maintain solid contact in damp conditions
• Every coil undergoes spark-gap load testing for consistent output

Fits These Machines

• for Ford Fusion 3.0L V6 (2006–2012)
• for Ford Escape 3.0L V6 (2008–2012)
• for Mercury Milan 3.0L V6 (2006–2011)
• for Mercury Mariner 3.0L V6 (2008–2011)

On-The-Job Use

• Clearing P0300–P0306 misfire codes triggered by worn coils or plugs
• Scheduled tune-up service on high-mileage 3.0L V6 engines
• Restoring throttle response and fuel economy in daily commuters
• Preventative coil and plug replacement before long-distance driving
• Complete driveway or garage ignition system overhauls

Specs At A Glance

Good To Know

Q: Do these coils require reprogramming or special tools? A: No programming is needed; the coils connect directly to the factory harness and work immediately with the vehicle’s ECU.

Q: Are the spark plugs gapped and ready to install? A: Yes, each plug arrives pre-gapped to the factory specification, so you can swap them in right out of the box.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.