703369 Door & Ignition Switch Lock Cylinder w/ Keys Fit 1997-18 Ford E-150 E-250

Door & Ignition Switch Lock Cylinder with Keys for Ford

This door and ignition switch lock cylinder kit with keys replaces worn ignition and door lock cylinders on 1997–2018 Ford E-150 and E-250 vans. Cross-references: 703369, F6UZ-1522050-AB, 6C3Z-1522050-A.

Overview

This door & ignition switch lock cylinder kit delivers a complete fix when the key won't turn in the ignition or the door lock is seized. The set includes one ignition lock cylinder, one door lock cylinder, and two matching keys, all pre-pinned so only one key is needed for starting and entry. Designed for fleet vans and service trucks, the assembly fits 1997 to 2018 Ford E-150 and E-250 models without modifying the steering column or door handle.

Built For Performance

• Ignition lock cylinder comes with the factory-style 7-blade electrical connector for plug-and-play installation.
• Door lock cylinder uses the OE-style push-button retainer, dropping into the handle without special tools.
• Zinc alloy housings on both cylinders resist corrosion from moisture and winter salt.
• Pre-lubricated tumbler wafers and springs maintain smooth key operation for years.
• Two keys are cut and coded to both cylinders, so one key controls the door and the ignition.
• Works with the vehicle's original key-in-ignition chime and shift interlock (where equipped).

Fits These Machines

• for Ford E-150 1997–2018
• for Ford E-250 1997–2018

On-The-Job Use

• Replacing a no-start condition where the ignition cylinder fails to turn or disengages the starter.
• Fleet maintenance on Ford E-Series cargo and passenger vans to minimize downtime.
• Restoring keyed entry after a break-in that damaged the door lock without replacing the whole door handle.
• Quickly swapping out a worn ignition switch that causes intermittent electrical accessories loss.
• DIY repair for contractors and delivery drivers who rely on their E-150 or E-250 daily.

Specs At A Glance

Good To Know

Q: Does this kit include a transponder key for PATS vehicles? A: No, the cylinder set does not contain a transponder chip. For vans equipped with PATS, the original transponder key must be programmed to the vehicle, or a separate transceiver ring must be retained.

Q: Will the door lock cylinder fit both the front and side/rear doors? A: The door lock cylinder is designed for the front driver-side door handle. It does not fit rear or cargo doors, which typically use a different cylinder design.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.