7061138 Outer Tie Rod End for Polaris Sportsman 800 EFI 6x6 2009

Outer Tie Rod End for Polaris Sportsman 800 EFI 6x6

This outer tie rod end replaces OEM part 7061138 on the Polaris Sportsman 800 EFI 6x6, restoring steering response by connecting the tie rod to the wheel hub assembly.

Overview

This outer tie rod end is a direct replacement steering component built for the Polaris Sportsman 800 EFI 6x6. It links the tie rod to the steering knuckle so the front wheels track correctly under load. It suits riders replacing a worn or bent tie rod end on a 2009 machine.

Built For Performance

• Replaces OEM part number 7061138
• Threaded stud design matches the original mounting setup
• Ball joint pivot allows smooth steering through the full range of travel
• Built from hardened steel for strength under off-road loads
• Dust boot helps keep grit and moisture out of the joint

Fits These Machines

• for Polaris Sportsman 800 EFI 6x6, 2009

On-The-Job Use

• Trail riding where steering precision matters on rutted ground
• Utility work with a loaded bed on uneven terrain
• Replacing a bent tie rod end after a rock strike
• Routine front end service on a high-hour machine

Specs At A Glance

Good To Know

Q: Do I need to replace both sides at once? A: If one tie rod end is worn, the other often is too, so many riders replace both at the same time. Always check the inner tie rod end and alignment after installation.

Q: Is an alignment needed after fitting this part? A: Yes, the front toe setting changes when a tie rod end is replaced, so a wheel alignment should follow. Confirm the part number matches your machine before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.