707000995 Air Temperature Pressure Sensor for Can-Am Commander 1000 2011-2023

Air Temperature/Pressure Sensor for Can-Am Commander 1000

This air temperature and pressure sensor, OEM cross-reference 707000995, measures intake air temperature and pressure so the engine control module can adjust fuel delivery on Can-Am Commander 1000 side-by-sides from 2011 through 2023.

Overview

This air temperature and pressure sensor is a direct-fit replacement for the factory unit on Can-Am Commander 1000 models. It reports intake air temperature and manifold pressure to the ECU, helping the engine run at the correct air-fuel ratio. It is built for owners doing routine maintenance or troubleshooting sensor faults.

Built For Performance

• Combined temperature and pressure sensing in one unit
• OEM cross-reference 707000995 for direct fitment
• Sealed housing that resists dust, moisture, and engine bay heat
• Plug-and-play electrical connector matching the factory harness
• Stable signal output for consistent ECU readings

Fits These Machines

• for Can-Am Commander 1000 (2011-2023)

On-The-Job Use

• Replacing a failed or drifting intake air sensor
• Restoring correct fuel trim on trail and utility rides
• Routine maintenance on high-hour machines
• Diagnosing rough idle or poor throttle response

Specs At A Glance

Good To Know

Q: Will this sensor need any programming after installation? A: No programming is required; the ECU reads it automatically once plugged in. Clear any stored fault codes after fitting the new sensor.

Q: How do I know if my air temperature and pressure sensor has failed? A: Common signs include a check engine light, rough idle, or poor fuel economy. A scan tool reading live data can confirm whether the sensor output is out of range.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.