707000995 Air Temperature Pressure Sensor for Can-Am Defender 1000 2016-2022

Air Temperature/Pressure Sensor for Can-Am Defender 1000

This air temperature and pressure sensor for Can-Am Defender 1000 monitors intake air conditions and sends that data to the engine management system, carrying OEM cross-reference 707000995.

Overview

This air temperature/pressure sensor for Can-Am Defender 1000 packs both temperature and pressure sensing into one housing that installs in the intake tract. It supplies the ECU with the readings needed for correct fuel and ignition delivery. It fits 2016 through 2022 Defender 1000 models as a replacement for a faulty original sensor.

Built For Performance

• Dual function design reads intake air temperature and pressure
• Direct cross-reference to OEM part number 707000995
• Factory-style connector plugs into the existing harness
• Sealed body stands up to dust, mud, and underhood heat
• Quick response to throttle and load changes

Fits These Machines

• for Can-Am Defender 1000, 2016-2022

On-The-Job Use

• Replaces a failed sensor causing drivability complaints
• Common service item during intake or tune-up work
• Helps maintain factory fuel mixture under load
• Suits trail, ranch, and heavy utility use

Specs At A Glance

Good To Know

Q: Does this sensor require programming after installation? A: No programming is needed, since the ECU reads its signal directly through the factory connector. Clear fault codes and check live data once it is fitted.

Q: What symptoms point to a bad sensor? A: Hesitation, rich or lean running, and stored intake air codes are typical signs. Inspect the connector and wiring before swapping the part.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.