707000995 Air Temperature Pressure Sensor for Can-Am Maverick 800 2018-2020

Air Temperature/Pressure Sensor for Can-Am Maverick 800

This air temperature and pressure sensor (OEM cross-reference 707000995) measures intake air conditions and relays that data to the engine management system on Can-Am Maverick 800 side-by-side vehicles from 2018 through 2020.

Overview

This air temperature and pressure sensor is a direct-fit replacement for the factory unit on Can-Am Maverick 800 models. It monitors both the temperature and pressure of incoming air so the ECU can adjust fuel delivery and ignition timing for reliable performance. It suits riders replacing a failed or dirty sensor during routine maintenance or a rebuild.

Built For Performance

• Combined temperature and pressure sensing in a single housing
• OEM cross-reference 707000995 for direct fitment
• Sealed connector to resist moisture and trail debris
• Plug-and-play installation with no wiring changes
• Housing built to withstand vibration and heat cycles

Fits These Machines

• for Can-Am Maverick 800 (2018-2020)

On-The-Job Use

• Trail riding where altitude and temperature shifts affect fueling
• Dune and desert runs with wide temperature swings
• Routine service after a sensor fault code appears
• Engine rebuilds and intake system repairs

Specs At A Glance

Good To Know

Q: Will this sensor fix a check engine light? A: If the stored code points to intake air temperature or pressure, replacing the faulty sensor commonly clears the fault. Always confirm the code before ordering.

Q: Is this an original Can-Am part? A: No, this is an aftermarket replacement that cross-references OEM number 707000995. It is designed to fit and function like the factory sensor.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.