707000995 Air Temperature Pressure Sensor for Can-Am Maverick Trail 800 2018-202

Air Temperature/Pressure Sensor for Can-Am

This air temperature and pressure sensor (OEM cross-reference 707000995) monitors intake air conditions so your engine management system can adjust fueling and ignition timing accurately.

Overview

This air temperature/pressure sensor is a direct replacement component for Can-Am side-by-side vehicles, delivering the intake air data your ECU needs to run correctly. It measures both air temperature and manifold pressure in one unit, helping maintain stable performance across changing conditions. It suits riders replacing a failed or out-of-spec sensor on their Can-Am machine.

Built For Performance

• Combines air temperature and pressure sensing in a single unit
• OEM cross-reference 707000995 for straightforward matching
• Plug-in electrical connection for a direct fit
• Sealed housing built to handle engine bay heat and vibration
• Supports accurate ECU fuel and timing calculations

Fits These Machines

• for Can-Am Maverick Trail 800 (2018-2021)

On-The-Job Use

• Trail riding where altitude and temperature shifts affect fueling
• Replacing a failed sensor that triggers a check engine light
• Routine maintenance on Can-Am Maverick Trail 800 models
• Restoring smooth idle and throttle response after sensor failure

Specs At A Glance

Good To Know

Q: Will this sensor fix a check engine light? A: If the fault code points to the intake air temperature or pressure sensor, replacing it with this unit addresses the source of the code.

Q: Does this sensor require programming after installation? A: No programming is typically needed; it connects to the existing harness and reports data to the ECU as the original did.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.