707000995 Air Temperature Pressure Sensor for Can-Am Outlander Max 6X6 450 2020-

Air Temperature/Pressure Sensor for Can-Am Outlander Max 6X6 450

This air temperature and pressure sensor for Can-Am Outlander Max 6X6 450 delivers the intake air readings your engine management system relies on for correct fuel and spark delivery.

Overview

The air temperature and pressure sensor for Can-Am Outlander Max 6X6 450 monitors incoming air temperature and manifold pressure so the ECU can fine-tune the air-fuel mixture. It fits 2020 through 2023 models and replaces a failed or reading-drift sensor with a direct-fit alternative. This sensor is for riders and mechanics servicing Can-Am Outlander Max 6X6 450 machines.

Built For Performance

• Combined temperature and pressure sensing in one unit
• Direct-fit electrical connector for the factory harness
• Sealed housing built to resist moisture, dust, and vibration
• Stable signal output across the full operating temperature range
• Mounts to the factory sensor location without modification

Fits These Machines

• for Can-Am Outlander Max 6X6 450, 2020-2023

On-The-Job Use

• Restoring correct fuel delivery on trail and utility rides
• Diagnosing and fixing rough idle or poor running conditions
• Routine replacement during engine or intake system service
• Fleet maintenance on multi-purpose and hunting rigs

Specs At A Glance

Good To Know

Q: What symptoms point to a bad air temperature and pressure sensor? A: Rough idle, poor throttle response, check engine lights, and rich or lean running are common signs. Replacing it restores accurate readings to the ECU.

Q: Does this sensor plug straight into the factory harness? A: Yes, it uses the factory-style connector and mounts at the original location. No wiring changes are needed on supported models.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.