707000995 Air Temperature Pressure Sensor for Can-Am Outlander Pro 570 2016-2020

Air Temperature/Pressure Sensor for Can-Am Outlander Pro 570

This air temperature/pressure sensor for Can-Am supports accurate intake readings on your machine, cross-referencing OEM part number 707000995.

Overview

This air temperature/pressure sensor for Can-Am is a direct-fit replacement that monitors intake air temperature and manifold pressure on your ATV. It feeds those readings to the engine management system so fuel delivery and timing stay dialed in. Ideal for riders replacing a failed or inaccurate sensor on a Can-Am Outlander Pro 570.

Built For Performance

• Combines air temperature and pressure sensing in a single unit
• Plugs into the factory harness connector
• Cross-references OEM part number 707000995
• Housing built to withstand engine bay heat and vibration
• Restores accurate intake data to the ECU

Fits These Machines

• for Can-Am Outlander Pro 570, 2016-2020

On-The-Job Use

• Trail riding where elevation and temperature shift constantly
• Utility work with sustained engine loads
• Cold-start conditions needing correct fuel enrichment
• Routine replacement of a failed intake sensor

Specs At A Glance

Good To Know

Q: Will this sensor need programming after install? A: No, it connects to the factory harness and the ECU reads it directly. Just clear any stored fault codes after fitting.

Q: What symptoms point to a bad air temperature/pressure sensor? A: Rough idle, poor fuel economy, and check engine lights are common signs. Replacing the sensor usually clears these once codes are reset.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.