707000995 Air Temperature Pressure Sensor for Can-Am Outlander XT 400 2008-2014
707000995 Air Temperature Pressure Sensor for Can-Am Outlander XT 400 2008-2014
Couldn't load pickup availability
Air Temperature/Pressure Sensor for Can-Am Outlander XT 400
This air temperature and pressure sensor, OEM cross-reference 707000995, monitors intake air conditions so your engine management system can adjust fuel delivery accurately.
Overview
This air temperature and pressure sensor is a direct-fit replacement for the Can-Am Outlander XT 400, reading manifold air temperature and pressure and relaying that data to the ECU for correct fuel trim. The sensor restores accurate readings when the original unit fails, helping the engine run cleanly through the full throttle range. It suits riders and mechanics performing routine diagnostics or rebuilding a 2008 through 2014 Outlander XT 400.
Built For Performance
- OEM cross-reference 707000995 for accurate replacement matching
- Combined temperature and pressure sensing in a single compact unit
- Weather-resistant connector housing for off-road conditions
- Sealed sensor element resists moisture and dust ingress
- Plug-in electrical connector for straightforward installation
- Direct-fit mounting to the factory intake location
Fits These Machines
- for Can-Am Outlander XT 400 (2008-2014)
On-The-Job Use
- Trail riding where consistent air-fuel ratios matter
- Diagnosing rough idle or poor throttle response
- Routine service on high-hour Outlander XT 400 engines
- Restoring factory ECU sensor data after a failure
Specs At A Glance
| Part Number(s) | 707000995 |
| Sensor Type | Air temperature and pressure |
| Machine Fitment | Can-Am Outlander XT 400 (2008-2014) |
| Position | Intake / manifold |
Good To Know
Q: How do I know if my air temperature sensor has failed? A: Common signs include a check engine light, rough idle, poor fuel economy, and hesitation under acceleration. A scan tool can confirm whether the sensor is sending implausible readings.
Q: Does this sensor require ECU reprogramming after install? A: No. This is a plug-and-play replacement that the factory ECU reads automatically once connected. Clear any stored fault codes after installation.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
