Skip to product information
1 of 1

707000995 Air Temperature Pressure Sensor for Can-Am Renegade XXC 850 2017-2021

707000995 Air Temperature Pressure Sensor for Can-Am Renegade XXC 850 2017-2021

Regular price $71.39
Regular price Sale price $71.39
Sale Sold out
Quantity

Air Temperature/Pressure Sensor for Can-Am Renegade XXC 850

This air temperature and pressure sensor, part number 707000995, monitors intake air conditions and relays that data to the engine management system on Can-Am Renegade XXC 850 machines.

Overview

The Air Temperature/Pressure Sensor for Can-Am Renegade XXC 850 measures incoming air temperature and manifold pressure so the ECU can adjust fuel delivery and ignition timing correctly. This sensor, carrying part number 707000995, is a direct-fit replacement for the original unit on 2017 through 2021 models. It suits riders and mechanics who need a dependable fix for rough running, poor idle, or check engine codes tied to intake air readings.

Built For Performance

  • Combined temperature and pressure sensing in one compact housing
  • Built to plug into the factory connector without rewiring
  • Housing resists heat, vibration, and moisture common to off-road use
  • Delivers consistent signal output to the engine control unit
  • Direct replacement for part number 707000995

Fits These Machines

  • for Can-Am Renegade XXC 850, 2017-2021

On-The-Job Use

  • Trail riding where altitude and temperature shifts affect fuel mixture
  • Cold starts where accurate intake readings aid quick warm-up
  • Mud, dust, and water crossings that can foul a worn sensor
  • Routine service when diagnosing check engine codes

Specs At A Glance

Part Number(s) 707000995
Type Air temperature and pressure sensor
Fitment Can-Am Renegade XXC 850, 2017-2021

Good To Know

Q: Will this sensor clear a check engine light? A: If the stored code points to intake air temperature or pressure readings, replacing the faulty sensor usually resolves it. Always clear codes after installation and confirm they do not return.

Q: Does it need calibration after fitting? A: No calibration is required, since the ECU reads the signal directly from the sensor. Just plug it in, secure the connector, and start the engine.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details