707000995 Air Temperature Pressure Sensor for Sea-Doo GTI P SE 90 900 2018

Air Temperature/Pressure Sensor for Sea-Doo

This air temperature and pressure sensor for Sea-Doo reads intake air conditions and reports them to the engine management system, cross-referencing part number 707000995.

Overview

This air temperature and pressure sensor for Sea-Doo delivers the intake air data the ECU needs to manage fuel delivery and ignition timing. It replaces the factory sensor on GTI P SE 90 and 900 machines from 2018. A direct-fit replacement for riders who need reliable sensor readings without the cost of an original unit.

Built For Performance

• Combines air temperature and manifold pressure sensing in a single unit
• Plug-in connection matches the factory harness
• Housing resists moisture and vibration common to watercraft use
• Cross-references part number 707000995
• Mounts to the original sensor location

Fits These Machines

• for Sea-Doo GTI P SE 90, 2018
• for Sea-Doo GTI 900, 2018

On-The-Job Use

• Replacing a failed or intermittent intake sensor
• Restoring accurate air temperature readings after fault codes
• Routine maintenance on 2018 GTI P SE 90 and 900 machines
• Diagnosing rough running or rich conditions traced to sensor data

Specs At A Glance

Good To Know

Q: Will this sensor need any programming after installation? A: No, this sensor is a plug-and-play replacement that communicates directly with the factory ECU once installed. Recheck for stored fault codes after the swap to confirm the system clears.

Q: How do I know the original sensor is the problem? A: Rough idle, poor fuel economy, or a stored intake air temperature code are common signs of a failed sensor. Confirm the wiring and connector are intact before replacing the unit.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.