711956740 Oil Filter for Sea-Doo Challenger SP 430 1503 2010-2011

Oil Filter for Sea-Doo

This oil filter fits the Sea-Doo Challenger SP 430 1503 for 2010 and 2011 and cross-references OEM part number 711956740, removing contaminants from engine oil as it circulates.

Overview

This oil filter is a replacement service part for the 1503 engine in the Sea-Doo Challenger SP 430. It traps dirt, metal debris, and sludge so clean oil reaches the bearings and top end. Cross-referenced to 711956740, it is a straightforward swap for the factory filter during routine maintenance.

Built For Performance

• Filter media captures fine particles that would accelerate engine wear
• Direct cross-reference to OEM part number 711956740
• Anti-drainback design keeps oil at the filter between starts
• Steel canister and base plate resist pressure spikes
• Sealing gasket holds a leak-free seal to the filter housing

Fits These Machines

• for Sea-Doo Challenger SP 430 (2010) with the 1503 engine
• for Sea-Doo Challenger SP 430 (2011) with the 1503 engine

On-The-Job Use

• Routine oil change intervals on the 1503 engine
• Spring pre-season service before launching
• End-of-season maintenance before winter storage
• Refreshing the oiling system after an engine repair

Specs At A Glance

Good To Know

Q: Can I use this filter in place of the factory filter? A: It is cross-referenced to OEM 711956740 and is intended as a direct service replacement for the listed machines.

Q: What else should be replaced at the same time? A: Most service schedules pair a new oil filter with fresh engine oil and a check of the O-ring or gasket at the filter housing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.