78.00 mm Cylinder Sleeve for Sea-Doo SPX 650 1994-1995

Cylinder Sleeve for Sea-Doo SPX 650

This 78.00 mm cylinder sleeve is a replacement engine component made to fit the Sea-Doo SPX 650 for the 1994 to 1995 model years, restoring a worn or scored cylinder bore so the top end can be rebuilt and run again.

Overview

This cylinder sleeve for Sea-Doo SPX 650 models gives you a fresh, true bore surface when the original cylinder has been damaged or worn beyond tolerance. The 78.00 mm cylinder sleeve is intended for riders and engine builders rebuilding a 650cc two-stroke top end who need a dependable replacement bore. Installed and machined to final size, the cylinder sleeve for Sea-Doo SPX 650 brings the cylinder back into usable condition for reassembly.

Built For Performance

• 78.00 mm bore size for the 650cc Sea-Doo engine platform
• Cast iron construction suited to watercraft cylinder re-sleeving
• Machined outer surface for a consistent press fit into the cylinder
• Restores a worn or scored bore surface during top-end rebuilds
• Designed as a replacement sleeve for the 1994 to 1995 SPX 650

Fits These Machines

• for Sea-Doo SPX 650, 1994
• for Sea-Doo SPX 650, 1995

On-The-Job Use

• Top-end rebuilds on 1994 to 1995 Sea-Doo SPX 650 watercraft
• Restoring cylinders with scored, pitted, or worn bores
• Engine machining work where a fresh bore must be installed and honed
• Shop and DIY rebuild projects for 650cc two-stroke engines

Specs At A Glance

Good To Know

Q: Does this sleeve come ready to run? A: Cylinder sleeves typically need to be pressed in and bored or honed to final size by a machine shop before use. Confirm the finished bore dimension with your builder.

Q: Will this fit my SPX 650? A: It is listed for the 1994 to 1995 Sea-Doo SPX 650 with a 78.00 mm bore. Verify your engine code and current bore before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.