8" Carbides for Polaris Indy 700 Dragon Switchback 2008 Pair
8" Carbides for Polaris Indy 700 Dragon Switchback 2008 Pair
Couldn't load pickup availability
8" Carbides for Polaris Indy 700 Dragon Switchback
This pair of 8 inch carbides fits the 2008 Polaris Indy 700 Dragon Switchback, delivering a sharp cutting edge on the ski runners for reliable steering on hardpack and ice.
Overview
These 8 inch carbides for Polaris Indy 700 Dragon Switchback models bring back the ski bite that trail riding depends on. Each pair mounts to the ski runners and carves a firmer line through packed snow and icy corners. Riders servicing a 2008 Indy 700 Dragon Switchback will find this carbide set a straightforward replacement for worn runners.
Built For Performance
- 8 inch carbide length provides solid grip on hardpack and ice
- Sold as a matched pair for both skis
- Carbide edge cuts a sharper line than plain steel runners
- Built as a direct replacement for the factory ski runner
- Suited to trail use where steering precision matters
Fits These Machines
- for Polaris Indy 700 Dragon Switchback, 2008
On-The-Job Use
- Trail riding where consistent cornering control is needed
- Hardpack and icy stretches that demand extra ski bite
- Replacing dull or rounded carbides before the season starts
- Routine ski runner maintenance on an Indy 700 Dragon Switchback
Specs At A Glance
| Carbide Length | 8 inches |
| Quantity | Pair |
| Type | Ski carbide wear bar |
Good To Know
Q: Do these carbides come as a pair? A: Yes, this listing includes two carbides so both skis can be fitted at once. They are intended for the 2008 Polaris Indy 700 Dragon Switchback.
Q: How often should carbides be replaced? A: Carbides wear down over trail miles and lose grip once the edge rounds off. Check them before each season and replace them when steering feels vague on hardpack.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
