852839 Trim Tilt Hydraulic Oil Hose for Volvo Penta 285A 290A 430A 430B 431A/B

Trim Tilt Hydraulic Oil Hose for Volvo Penta 285A 290A 430A 430B 431A/B

This trim tilt hydraulic oil hose, cross-referenced as 852839, is a direct replacement hydraulic hose designed to transfer fluid within the trim and tilt system of select Volvo Penta outdrive models. It replaces worn or leaking original hoses to restore reliable hydraulic operation. This trim tilt hydraulic oil hose is built for the demands of marine hydraulic systems.

Overview

This trim tilt hydraulic oil hose is a replacement hydraulic line for Volvo Penta sterndrive and outdrive units. It carries pressurized hydraulic fluid between the pump, reservoir, and tilt cylinder to raise and lower the drive. This trim tilt hydraulic oil hose is crafted to match the original hose routing and connections for a straightforward replacement.

Built For Performance

• Reinforced hydraulic hose construction withstands high system pressure
• Pre-formed ends and routing match original Volvo Penta hose geometry
• Oil-resistant inner lining ensures long service life with hydraulic fluid
• Corrosion-resistant fittings for prolonged marine environment exposure
• Direct replacement for OEM part number 852839

Fits These Machines

• for Volvo Penta 285A
• for Volvo Penta 290A
• for Volvo Penta 430A
• for Volvo Penta 430B
• for Volvo Penta 431A/B

On-The-Job Use

• Commonly used during outdrive servicing to replace cracked or leaking tilt hoses
• Supports trim system maintenance on sterndrive boats in saltwater or freshwater
• Installed when rebuilding or repairing the hydraulic tilt mechanism

Specs At A Glance

Good To Know

Q: How do I know this hose fits my Volvo Penta drive?A: Check your outdrive model and serial number against the listed compatible models (285A, 290A, 430A, 430B, 431A/B) to confirm fitment before ordering.

Q: What should I do if my old hose has a different routing?A: Compare the routing and connector type with your original hose; this replacement is designed to match OEM specifications, but verify your drive's configuration.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.