8CR-26330-01-00 Choke Cable for Yamaha Venture 500 1997-2001

Choke Cable for Yamaha Venture 500

This choke cable is a direct replacement for the factory starter enrichment cable on Yamaha Venture 500 snowmobiles, allowing you to operate the choke from the handlebar. It cross-references OEM part number 8CR-26330-01-00.

Overview

This choke cable for Yamaha Venture 500 models gives you reliable control over the carburetor enrichment circuit from the driver's position. The choke cable replaces a worn or broken original, restoring cold-start function so your engine fires up when temperatures drop. It is built to match the routing and length of the factory choke cable for a straightforward installation.

Built For Performance

• Constructed to match the OEM 8CR-26330-01-00 configuration
• Inner cable slides smoothly for consistent choke actuation
• Protective outer housing resists moisture and abrasion
• Correct length and fittings for direct routing on Venture 500 models
• Handlebar-mounted lever end for easy operation while seated

Fits These Machines

• for Yamaha Venture 500 1997
• for Yamaha Venture 500 1998
• for Yamaha Venture 500 1999
• for Yamaha Venture 500 2000
• for Yamaha Venture 500 2001

On-The-Job Use

• Cold starts on trail rides in low temperatures
• Seasonal tune-ups and cable replacement
• Restoring choke control on older snowmobiles
• Routine maintenance before winter riding season

Specs At A Glance

Good To Know

Q: Is this an original Yamaha part? A: No, this is an aftermarket choke cable built to cross-reference OEM part number 8CR-26330-01-00. Always confirm your machine's serial number and existing part before ordering.

Q: Do I need to remove the carburetor to install it? A: On most Venture 500 models the cable can be routed and connected without removing the carburetor. Refer to your service manual for the exact procedure.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.