9" Diameter Rear Jack Foot Pad For 2" I.D Square Tube LC Hall Effect Ground

9" Diameter Rear Jack Foot Pad for LC

This 9-inch diameter rear jack foot pad fits 2-inch inner diameter square tubes and works with LC Hall Effect ground sensing systems to provide stable support for RV leveling jacks.

Overview

The 9" diameter rear jack foot pad is a replacement pad that spreads weight over a larger surface, preventing sinking on soft ground. Designed for rear jacks with 2" I.D. square tubing, this 9" diameter rear jack foot pad interfaces directly with LC Hall Effect leveling controls. It helps maintain accurate ground detection and improves stability during setup.

Built For Performance

• 9-inch diameter distributes weight for less ground pressure
• Fits 2-inch inner diameter square tubing precisely
• Compatible with LC Hall Effect ground sensing circuit
• Corrosion-resistant finish for outdoor exposure
• Reinforced attachment point to handle jack torque
• Easy bolt-on or slip-on installation

On-The-Job Use

• Leveling a travel trailer or fifth wheel on uneven campsites
• Stabilizing a motorhome rear section during setup
• Replacing a damaged or rusty original foot pad
• Upgrading ground contact for automatic leveling systems
• Using with aftermarket LC Hall Effect retrofit kits

Specs At A Glance

Good To Know

Q: How do I know if my rear jack uses LC Hall Effect ground sensing? A: Check your leveling control panel for an LC or Lippert Components label; the Hall Effect system uses a magnetic sensor to detect ground contact.

Q: Will this foot pad fit a jack with a round tube instead of square? A: No, it is specifically designed for 2-inch inner diameter square tubing and will not fit round jack legs.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.