900 Ribbon Remover for Sea-Doo Spark 3Up HO 2015-2024

Ribbon Remover for Sea-Doo Spark 3Up HO 900

The Ribbon Remover for Sea-Doo Spark 3Up HO 900 fits 2015-2024 models and makes short work of cutting the factory ribbon sealant that bonds the top deck to the hull.

Overview

This Ribbon Remover is built for the ribbon sealant seam on the Sea-Doo Spark 3Up HO 900, the high output three-up version of the Spark platform. It lets owners and techs slice through the factory bonding material with steady control instead of fighting it with improvised blades. The Ribbon Remover suits anyone pulling a deck for hull repair, resealing, or a full rebuild on the Spark 3Up HO 900.

Built For Performance

• Profile matched to the deck-to-hull seam on the Spark 3Up HO 900
• Sharp edge cuts ribbon sealant cleanly with light, even pressure
• Rigid body resists flex so passes stay straight along the channel
• Blade geometry keeps gelcoat and composite panels out of the cut path
• Fits into the tight tub and footwell areas of the Spark hull

Fits These Machines

• for Sea-Doo Spark 3Up HO 900, 2015-2024

On-The-Job Use

• Removing the top deck for hull inspection and repair
• Separating deck and hull before fresh sealant is applied
• Restoration work on older Spark 3Up HO 900 units
• Service shops handling multiple Spark tear-downs

Specs At A Glance

Good To Know

Q: Is this Ribbon Remover the same tool for both the 2Up and 3Up Spark hulls? A: The seam layout on the Spark 3Up HO 900 is what this tool is built around, so fit is confirmed for that platform. Check your exact model year before ordering if you run multiple Spark variants.

Q: How much force does it take to cut through the ribbon sealant? A: The tool is designed to cut with light, repeated passes along the seam rather than heavy pressure. Forcing it can walk the blade off the channel and into finished surfaces.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.