900 Ribbon Remover for Sea-Doo Spark DT 2014 Fits

Ribbon Remover for Sea-Doo Spark DT 900

This Ribbon Remover is a replacement wear ring component made for the Sea-Doo Spark DT 900, designed to keep the impeller-to-housing clearance tight so the jet pump moves water efficiently.

Overview

This Ribbon Remover is built for the Sea-Doo Spark DT 900 and serves as a protective wear ring inside the jet pump assembly. The Ribbon Remover shields the pump housing from impeller contact while helping maintain consistent water flow. It is intended for riders and mechanics servicing a Sea-Doo Spark DT 900 jet pump.

Built For Performance

• Direct-fit replacement wear ring for the Sea-Doo Spark DT 900 jet pump
• Maintains proper impeller clearance for steady thrust
• Shields the pump housing from abrasive wear
• Withstands repeated water and debris exposure
• Simple drop-in install during pump service

Fits These Machines

• for Sea-Doo Spark DT 900, 2014

On-The-Job Use

• Routine jet pump rebuilds
• Wear ring replacement after sand or gravel ingestion
• Seasonal pre-ride maintenance on personal watercraft
• Restoring pump efficiency on aging impellers

Specs At A Glance

Good To Know

Q: How do I know the ribbon remover needs replacing? A: Common signs include vibration, cavitation, or a drop in top speed as the impeller clearance opens up. Inspecting the wear ring each time the pump is off the water helps you catch wear early.

Q: Does this fit both the 2-up and 3-up Spark? A: This item is listed for the Sea-Doo Spark DT 900, so verify your exact year and engine variant before ordering. Confirm serial number compatibility with your pump assembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.