92045-3745 Jet Pump Bearing for Kawasaki Ultra 250X 1500 2007-2008

Jet Pump Bearing for Kawasaki

This jet pump bearing, referenced under OEM 92045-3745, supports the pump shaft in personal watercraft so the impeller spins true under load.

Overview

This jet pump bearing is a replacement component for the pump assembly on Kawasaki Ultra 250X 1500 watercraft from 2007 to 2008. The jet pump bearing carries radial load from the driveshaft, helping the impeller run smoothly and reducing vibration at speed. It suits riders and shops rebuilding a pump that has developed noise, play, or rough rotation.

Built For Performance

• OEM cross-reference 92045-3745 for direct matching
• Sealed bearing design that holds grease in and water out
• Hardened steel races for wear resistance under continuous load
• Built to handle the thrust and side load of a jet pump shaft
• Precision tolerances for quiet, smooth impeller rotation

Fits These Machines

• for Kawasaki Ultra 250X 1500, 2007
• for Kawasaki Ultra 250X 1500, 2008

On-The-Job Use

• Rebuilding a jet pump during routine maintenance
• Replacing a noisy or rough-spinning pump bearing
• Servicing a pump after ingesting sand or debris
• Shop repairs on Ultra 250X 1500 watercraft

Specs At A Glance

Good To Know

Q: How do I know if my pump bearing needs replacing? A: Grinding, rumbling, or shaft play when you turn the impeller by hand usually points to a worn bearing that should be replaced.

Q: Should I replace other pump parts at the same time? A: When the pump is apart, inspect seals, wear rings, and the impeller for damage and replace anything that shows wear.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.