92055-3748 Generator Cover O-Ring for Kawasaki Ultra 150 1200 1999-2005

Generator Cover O-Ring for Kawasaki

This generator cover O-ring for Kawasaki is a replacement sealing component that sits between the generator cover and engine case to prevent oil leaks on Ultra 150 1200 personal watercraft, referencing OEM part number 92055-3748.

Overview

This generator cover O-ring for Kawasaki seals the mating surface between the generator cover and the engine case on Ultra 150 1200 watercraft. It keeps oil where it belongs and shields the generator area from moisture and debris. The O-ring cross-references OEM part number 92055-3748 for easy verification.

Built For Performance

• Oil-resistant rubber construction suited to constant crankcase exposure
• Dimensional tolerances match the generator cover sealing groove
• Withstands the heat cycling typical of PWC engine operation
• Compresses evenly to form a consistent seal across the cover face
• Lightweight part that installs with standard hand tools

Fits These Machines

• for Kawasaki Ultra 150 1200, 1999-2005

On-The-Job Use

• Generator cover removal and reinstallation during engine service
• Seal replacement when oil weeps from the cover mating surface
• Routine maintenance on Ultra 150 1200 personal watercraft
• Preventive replacement whenever the generator cover is off

Specs At A Glance

Good To Know

Q: When should the generator cover O-ring be replaced? A: Replace it any time the generator cover is removed, and immediately if oil is seeping from the cover seam on your Ultra 150 1200. Old O-rings flatten and lose sealing ability over time.

Q: Is this an original Kawasaki part? A: This is an aftermarket generator cover O-ring made to fit Kawasaki Ultra 150 1200 models, cross-referenced to OEM number 92055-3748. It is not an original factory part.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.