92055-3761 Generator Cover O-Ring for Kawasaki Ultra 260X 1500 2009-2010

Generator Cover O-Ring for Kawasaki

This generator cover O-ring for Kawasaki seals the cover-to-engine mating surface on the Ultra 260X 1500, cross-referencing OEM part 92055-3761.

Overview

This generator cover O-ring for Kawasaki is a replacement sealing ring made to sit between the generator cover and the engine case on the Ultra 260X 1500. It keeps oil contained at the cover joint while blocking dirt and moisture from reaching the generator area. Install it during a cover service or gasket refresh on a 2009-2010 Ultra 260X 1500.

Built For Performance

• Cross-references OEM part number 92055-3761
• Ring profile sized to the generator cover groove for a seated fit
• Flexible rubber construction tolerates heat cycling and vibration
• Seals the cover joint against oil weep and external contamination
• Direct-fit replacement for the original ring during cover service

Fits These Machines

• for Kawasaki Ultra 260X 1500 (2009-2010)

On-The-Job Use

• Generator cover removal and reinstall
• Seasonal gasket and seal refresh
• Leak correction at the cover joint
• Top-end and cover-off engine service

Specs At A Glance

Good To Know

Q: Should this O-ring be replaced every time the cover comes off? A: It is good practice to fit a fresh O-ring any time the generator cover is removed, since a reused ring can harden or flatten and leak. A: A new ring helps the cover joint seal correctly on reassembly.

Q: Does this O-ring need sealant? A: O-rings of this type normally seat dry in their groove without gasket compound. Keep the groove clean and free of old material before fitting.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.