92055-3761 Generator Cover O-Ring for Kawasaki Ultra LX 1500 2007-2022

Generator Cover O-Ring for Kawasaki Ultra LX 1500

This generator cover O-ring, reference 92055-3761, seals the generator cover on Kawasaki Ultra LX 1500 watercraft to keep oil where it belongs and water out of the engine bay.

Overview

This generator cover O-ring is a direct-fit sealing component for the Kawasaki Ultra LX 1500, built to the 92055-3761 reference so you can match it to your original part. The O-ring sits between the generator cover and the engine case, holding a tight seal against oil seepage and moisture intrusion. It is aimed at personal watercraft owners and mechanics handling routine cover service or a full rebuild.

Built For Performance

• Formed to the 92055-3761 O-ring reference for a precise fit
• Rubber construction resists oil, heat, and water exposure
• Round cross-section compresses evenly for a consistent seal
• Designed for the generator cover mating surface on the Ultra LX 1500 engine
• Sold as a single replacement O-ring

Fits These Machines

• for Kawasaki Ultra LX 1500, 2007-2022

On-The-Job Use

• Generator cover resealing during engine service
• Top-end or full engine rebuilds
• Fixing oil weep around the generator cover
• Preventive replacement while the cover is off

Specs At A Glance

Good To Know

Q: Should this O-ring be replaced every time the generator cover comes off? A: Yes, a fresh O-ring is the reliable practice since the old one takes a compression set and may not seal again. It is a low-cost part that protects against oil leaks and water entry.

Q: Does this O-ring need sealant during installation? A: No, it is designed to seal on compression alone once the cover is torqued to spec. Keep the mating surfaces clean and free of old gasket material for the best result.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.