92055-3769 Crankshaft Generator O-Ring for Kawasaki STX 160 1500 2020-2026

Crankshaft Generator O-Ring for Kawasaki

This crankshaft generator O-ring seals the generator housing on Kawasaki STX 160 and 1500 personal watercraft, cross-referencing OEM part number 92055-3769 to keep oil contained and water out of the crankcase assembly.

Overview

This crankshaft generator O-ring is a replacement sealing component made for Kawasaki STX 160 and 1500 watercraft produced from 2020 through 2026. The crankshaft generator O-ring seats between the generator cover and crankcase to prevent oil seepage and block moisture intrusion around the crankshaft. It suits riders performing routine engine resealing or rebuilding a Kawasaki 1500 series engine.

Built For Performance

• Cross-references OEM part number 92055-3769 for direct fitment
• Formed from oil-resistant rubber compound for long-term sealing
• Precision sizing to seal the generator housing mating surface
• Withstands the heat and vibration of marine engine operation
• Resists fuel, oil, and water exposure common in PWC crankcases

Fits These Machines

• for Kawasaki STX 160
• for Kawasaki STX 1500
• for Kawasaki STX 160 2020-2026

On-The-Job Use

• Generator housing resealing during engine service
• Crankcase reassembly after rebuilds
• Oil leak repair around the crankshaft generator area
• Routine gasket and seal replacement on Kawasaki 1500 engines

Specs At A Glance

Good To Know

Q: Is this O-ring an original Kawasaki part? A: No, this is an aftermarket replacement O-ring that cross-references OEM number 92055-3769. Confirm your engine serial number before ordering.

Q: Does this O-ring come with installation hardware? A: This listing covers the O-ring seal only, so reuse or source any cover bolts separately as needed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.