92055-3769 Crankshaft Generator O-Ring for Kawasaki STX 160X 1500 2020-2026

Crankshaft Generator O-Ring for Kawasaki

The Crankshaft Generator O-Ring for Kawasaki seals the crankshaft generator housing, cross-referenced to OEM part number 92055-3769, to keep oil contained and water out of the generator cavity.

Overview

This Crankshaft Generator O-Ring for Kawasaki is a direct-fit sealing component for the generator housing on STX 160X 1500 watercraft. It seats between the crankcase and generator cover to prevent oil seepage and block moisture intrusion. Suitable for riders performing routine rebuilds or servicing a leaking seal on their personal watercraft.

Built For Performance

• Exact OEM cross-reference 92055-3769 for dependable fitment
• Constructed from oil-resistant rubber compound for long service life
• Precision-molded diameter matches the generator housing groove
• Withstands continuous heat cycles from the engine bay
• Resists water and salt exposure common in marine use

Fits These Machines

• for Kawasaki STX 160X 1500, 2020-2026

On-The-Job Use

• Replacing a worn or leaking generator housing seal
• Top-end or bottom-end engine service on STX 160X 1500 models
• Preventive maintenance during seasonal winterization
• Post-submersion repair to reseal the generator cavity

Specs At A Glance

Good To Know

Q: Is this an original Kawasaki part? A: No, this is an aftermarket replacement O-ring cross-referenced to OEM part number 92055-3769. Always confirm against your machine's parts diagram before ordering.

Q: Should this O-ring be lubricated before installation? A: A light coat of clean engine oil or silicone grease helps the O-ring seat without twisting. Replace any O-ring that shows flattening, cracking, or hardening.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.