92055-3769 Crankshaft Generator O-Ring for Kawasaki SX-R 160 1500 2024

Crankshaft Generator O-Ring for Kawasaki

This crankshaft generator O-ring for Kawasaki seals the generator cover area on the SX-R 160 1500 and cross-references OEM part number 92055-3769.

Overview

This crankshaft generator O-ring for Kawasaki is a sealing component that fits between the generator cover and the crankcase on the SX-R 160 1500. It keeps oil contained and blocks moisture and debris from reaching the generator area. This crankshaft generator O-ring is intended for riders performing routine maintenance or a top-end rebuild on a 2024 SX-R 160 1500.

Built For Performance

• OEM cross-reference 92055-3769 for direct fitment matching
• Rubber construction resists oil, heat, and water exposure
• Seals the generator cover to prevent oil weep and contamination
• Compact profile designed for the SX-R 160 1500 engine case
• Simple replacement during routine tear-down or rebuild work

Fits These Machines

• for Kawasaki SX-R 160 1500, 2024

On-The-Job Use

• Generator cover resealing during engine service
• Crankcase reassembly after a top-end or bottom-end rebuild
• Routine replacement when chasing oil seepage near the cover

Specs At A Glance

Good To Know

Q: Should this O-ring be replaced every time the generator cover comes off? A: Yes, a fresh O-ring is standard practice whenever the cover is removed, since used ones can flatten and leak. It is a low-cost part that protects the generator area from oil and moisture.

Q: Does this O-ring require any sealant during installation? A: It is designed to seal on its own once seated correctly in its groove. Keep the surface clean and free of old gasket residue before fitting.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.