93101-30M32-00 Jet Pump Oil Seal for Yamaha Wave Jammer 500 1989-1990

Jet Pump Oil Seal for Yamaha Wave Jammer 500

This jet pump oil seal for Yamaha Wave Jammer 500 personal watercraft replaces OEM part number 93101-30M32-00, sealing the pump shaft to keep water out and lubricant in.

Overview

This jet pump oil seal is a direct replacement sealing component for the Yamaha Wave Jammer 500 jet drive. It keeps water out of the pump bearing housing and holds lubricant where it belongs, protecting internal components from corrosion and wear. Suitable for riders performing routine pump maintenance or rebuilding a worn jet pump.

Built For Performance

• Direct replacement for OEM part number 93101-30M32-00
• Seals the pump shaft against water intrusion
• Retains lubricant inside the bearing housing
• Constructed from fuel and water resistant sealing material
• Designed for marine jet pump operating conditions

Fits These Machines

• for Yamaha Wave Jammer 500 (1989-1990)

On-The-Job Use

• Routine jet pump maintenance and inspection
• Pump rebuilds after water intrusion
• Seasonal servicing before launch
• Replacing worn or leaking pump seals

Specs At A Glance

Good To Know

Q: How do I know if my jet pump oil seal needs replacing? A: Milky or water contaminated pump oil, oil leaking from the pump housing, or excessive shaft play usually point to a failed seal. Inspect the pump after any impact or if the craft sat with water in the bilge.

Q: Does this seal fit both the Wave Jammer 500 model years listed? A: It is listed for the 1989-1990 Yamaha Wave Jammer 500 and matches OEM part number 93101-30M32-00. Confirm your pump assembly and serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.