936-700 Rear Driveshaft For 96-2004 Toyota Tacoma 4WD 3.4L A/Trans 2.7L M/Trans

936-700 Rear Driveshaft for Toyota Tacoma

This 936-700 rear driveshaft transfers torque from the transfer case to the rear axle, serving as a direct replacement for 1996-2004 Toyota Tacoma 4WD models with the 3.4L automatic or 2.7L manual transmission.

Overview

This 936-700 rear driveshaft prop shaft is built to carry rotational power to the rear differential on compatible 1996-2004 Toyota Tacoma 4WD trucks. It matches the OEM 936-700 reference so the flange and slip yoke align with the original driveline geometry for a straightforward install. It is intended for truck owners and shops replacing a worn, bent, or vibrating rear shaft on 4WD Tacoma builds with the 3.4L automatic or 2.7L manual transmission.

Built For Performance

• Balanced steel tube keeps driveline vibration low at highway speed
• Welded yoke ends configured to match the factory flange and slip joint
• Corrosion-resistant finish stands up to mud, salt, and road spray
• Built to handle the torque loads of 4WD Tacoma drivetrains
• Designed as a bolt-on replacement with no fabrication needed

Fits These Machines

• for Toyota Tacoma 4WD 1996-2004 with 3.4L and automatic transmission
• for Toyota Tacoma 4WD 1996-2004 with 2.7L and manual transmission

On-The-Job Use

• Replacing a bent or unbalanced rear shaft after off-road impacts
• Fixing driveline vibration and clunking on high-mileage 4WD trucks
• Restoring smooth torque transfer for daily driving and trail use
• Shop repairs where an OEM-style rear shaft is needed quickly

Specs At A Glance

Good To Know

Q: Does this shaft come balanced and ready to install? A: Yes, the tube and yokes are assembled and balanced as a unit so it mounts to the factory flanges without extra work in most cases. Q: Will it fit either transmission listed? A: It is built for the 3.4L automatic and 2.7L manual 4WD Tacoma, so confirm your cab, bed, and driveline length before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.