9600XS Ring Set 96.00mm for Wiseco 96.00mm Piston Ring Set

Ring Set for Wiseco

This 96.00mm ring set is a replacement piston ring assembly made to fit Wiseco 96.00mm pistons, restoring compression and oil control in a rebuilt top end.

Overview

This ring set delivers a fresh sealing surface for a 96.00mm piston during a top end rebuild. Each ring set is sized for 96.00mm bores so the piston ring set seats correctly and holds compression. It suits riders and engine builders refreshing a worn or damaged top end.

Built For Performance

• 96.00mm bore sizing for a matched fit to the piston
• Ring set configuration covering compression and oil control rings
• Replacement rings for a rebuild rather than reusing worn parts
• Consistent ring tension for stable sealing against the cylinder wall
• Sold as a complete set for one piston

Specs At A Glance

Good To Know

Q: How do I know this ring set matches my piston? A: Match the 96.00mm bore size and the 9600ZV part number to your piston before ordering. Ring sets are bore and piston specific, so the wrong size will not seal correctly.

Q: Can I install these rings without checking end gap? A: No, ring end gap should always be measured and set during assembly. Confirm the gap falls within the spec for your engine before final installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.