Accelerator Pedal Sensor for Cadillac Escalade Chevy Avalanche 1500 2500 2003-05

Accelerator Pedal Sensor for Cadillac and Chevy

This accelerator pedal sensor translates pedal position into an electronic signal for the throttle system on 2003-2005 Cadillac Escalade and Chevy Avalanche 1500 and 2500 models, restoring proper throttle response when the original sensor fails.

Overview

This accelerator pedal sensor is a replacement electronic component for the drive-by-wire throttle system on select 2003-2005 Cadillac Escalade and Chevy Avalanche 1500 and 2500 trucks. It reads pedal travel and sends the corresponding signal to the engine control module so the throttle opens in step with driver input. A practical fix for a vehicle showing reduced power, hesitation, or a throttle-related warning.

Built For Performance

• Electronic sensor assembly matches the pedal position input design
• Plug-in electrical connection for straightforward replacement
• Housing built to withstand vibration and temperature swings in the footwell
• Designed for consistent signal output across the pedal travel range
• Direct-fit mounting to the accelerator pedal assembly

Fits These Machines

• for Cadillac Escalade 2003-2005
• for Chevy Avalanche 1500 2003-2005
• for Chevy Avalanche 2500 2003-2005

On-The-Job Use

• Restoring throttle response when the pedal sensor fails
• Repairing drive-by-wire throttle faults on full-size GM trucks and SUVs
• Replacement during accelerator pedal service
• Addressing hesitation or reduced power complaints traced to pedal input

Specs At A Glance

Good To Know

Q: Will this sensor need calibration after installation? A: Many applications relearn pedal position automatically, but a scan tool may be needed to clear codes and confirm calibration. Check your service information for the specific procedure.

Q: What symptoms point to a failing pedal sensor? A: Reduced engine power, hesitation, an erratic idle, or a throttle-related warning light are common signs. Diagnose the fault before replacing parts to confirm the sensor is the cause.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.