Air Temperature Pressure Sensor for Can-Am Outlander 6X6 Pro 1000 2018-2020

Air Temperature/Pressure Sensor for Can-Am Outlander 6X6 Pro 1000

This air temperature and pressure sensor monitors intake air conditions so the engine control module can adjust fuel delivery on 2018 to 2020 Outlander 6X6 Pro 1000 models.

Overview

This air temperature and pressure sensor is a direct-fit replacement for the factory unit on the Outlander 6X6 Pro 1000. It reads incoming air temperature and manifold pressure, then sends that data to the ECU for accurate fuel and timing calculations. Suited to riders maintaining their own machine or shops doing routine service.

Built For Performance

• Combines air temperature and pressure sensing in one housing
• Plug-and-play electrical connector matches the factory harness
• Sealed body resists moisture, dust, and engine bay heat
• Restores accurate ECU readings for consistent fuel delivery
• Direct replacement footprint for the original sensor location

Fits These Machines

• for Can-Am Outlander 6X6 Pro 1000 (2018)
• for Can-Am Outlander 6X6 Pro 1000 (2019)
• for Can-Am Outlander 6X6 Pro 1000 (2020)

On-The-Job Use

• Trail and utility riding in changing altitude and temperature
• Hauling and towing with the 6X6 Pro drivetrain
• Seasonal maintenance when sensor faults trigger warning codes
• Workshop diagnostics and replacement of failed intake sensors

Specs At A Glance

Good To Know

Q: Will this sensor need reprogramming after install? A: No, it is a plug-in replacement that the ECU reads automatically once connected. Clear any stored fault codes after fitting.

Q: How do I know the sensor has failed? A: Common signs include rough running, poor fuel economy, or a check engine light with intake air codes. Confirm the fault with a diagnostic scan before replacing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.