Air Temperature Pressure Sensor for Can-Am Outlander Max 6X6 Pro 1000 2020

Air Temperature/Pressure Sensor for Can-Am Outlander Max 6X6 Pro 1000

This air temperature and pressure sensor measures intake air conditions and relays that data to the engine management system on your 2020 Can-Am Outlander Max 6X6 Pro 1000.

Overview

This air temperature and pressure sensor is a direct-fit replacement for the factory unit on the Can-Am Outlander Max 6X6 Pro 1000. It monitors intake air temperature and manifold pressure so the ECU can adjust fuel delivery and ignition timing correctly. A smart choice for riders replacing a failed or erratic sensor on a 2020 model.

Built For Performance

• Combines temperature and pressure sensing in a single housing
• Plug-and-play connector matches the factory harness
• Sealed body resists moisture, dust, and vibration
• Thermistor and pressure element calibrated for accurate readings
• Compact footprint fits the stock mounting location

Fits These Machines

• for Can-Am Outlander Max 6X6 Pro 1000, 2020

On-The-Job Use

• Restores correct fuel trim after a sensor failure
• Helps clear lean or rich running conditions
• Supports stable idle and throttle response on trail rides
• Ideal for routine maintenance on high-hour machines

Specs At A Glance

Good To Know

Q: Will this sensor need programming after install? A: No, it reads directly to the ECU and requires no calibration on this machine. Q: Can a bad sensor cause poor running? A: Yes, a failed air temperature and pressure sensor often causes rough idle, hesitation, or a check engine light.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.