Air Temperature Pressure Sensor for Sea-Doo Spark TRIXX 3Up 900 2017-2022

Air Temperature/Pressure Sensor for Sea-Doo

This air temperature and pressure sensor is a direct replacement component that monitors intake air conditions on your personal watercraft engine.

Overview

This air temperature and pressure sensor for Sea-Doo reads incoming air conditions so the engine control module can adjust fuel delivery and timing correctly. The combined sensor handles both temperature and pressure readings in one compact unit for 2017 through 2022 Spark TRIXX 3Up 900 models. It is the right part for riders who want reliable sensor feedback and smooth engine response on the water.

Built For Performance

• Combined temperature and pressure sensing in a single unit
• Direct fitment for factory sensor location
• Sealed connector to resist moisture and spray
• Built to handle the heat and vibration of marine use
• Restores accurate air readings to the engine control module

Fits These Machines

• for Sea-Doo Spark TRIXX 3Up 900, 2017-2022
• for Sea-Doo Spark 900 models sharing the same sensor location

On-The-Job Use

• Diagnosing rough running or poor throttle response
• Replacing a failed or contaminated sensor
• Routine engine maintenance and tune-ups

Specs At A Glance

Good To Know

Q: How do I know if my sensor has failed? A: Common signs include rough idling, poor acceleration, and error codes tied to intake air readings. A diagnostic scan can confirm whether the sensor is the source.

Q: Can I install this sensor myself? A: On most Spark models the sensor sits in an accessible location and swaps out with basic hand tools. Disconnect the battery before starting the job.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.