ATC200M ATC200S ATC200X Inner Clutch Cover Gasket for Honda 1983-1985

Inner Clutch Cover Gasket for Honda ATC200M, ATC200S, ATC200X

This inner clutch cover gasket is a direct replacement sealing component that fits between the clutch cover and engine case on 1983-1985 Honda ATC200M, ATC200S, and ATC200X three-wheelers to prevent oil leaks.

Overview

This inner clutch cover gasket is made to seal the clutch cover mating surface on 1983-1985 Honda ATC200M, ATC200S, and ATC200X models. The gasket keeps engine oil contained while protecting the clutch assembly from dirt and debris. It is a practical replacement for worn, torn, or oil-soaked gaskets during routine clutch service.

Built For Performance

• Precision-cut to match the inner clutch cover bolt pattern and port openings
• Oil-resistant gasket material resists swelling and breakdown from engine heat
• Provides a consistent seal across the full mating surface
• Thin profile maintains correct clutch cover spacing
• Designed as a direct-fit replacement for the original gasket

Fits These Machines

• for Honda ATC200M 1983-1985
• for Honda ATC200S 1983-1985
• for Honda ATC200X 1983-1985

On-The-Job Use

• Clutch cover removal and reassembly during clutch plate service
• Bottom end reseal when chasing oil seepage around the clutch cover
• Routine maintenance on 1983-1985 Honda ATC200-series three-wheelers
• Engine rebuilds where the clutch cover gasket is replaced as a matter of course

Specs At A Glance

Good To Know

Q: Does this gasket require sealant during installation? A: A dry install is typically sufficient on a clean, flat mating surface, though a light gasket dressing can help hold it in place during assembly.

Q: Should the clutch cover bolts be re-torqued after installation? A: Yes, recheck the bolts after the first heat cycle and again after a few hours of riding to keep the seal tight.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.