Bearing Housing for Yamaha 212 SS 1100 2008-2010

Bearing Housing for Yamaha

This bearing housing is a replacement driveline component built to support the pump shaft bearings on Yamaha 212 SS 1100 watercraft from 2008 through 2010.

Overview

This bearing housing serves as the mounting and support point for the pump shaft bearings on Yamaha 212 SS 1100 models. It keeps the shaft aligned and stable so the jet pump can transfer power smoothly. It is intended for owners servicing or rebuilding the driveline on their 2008 to 2010 Yamaha 212 SS 1100.

Built For Performance

• Rigid housing body that holds the pump shaft bearing in correct alignment
• Machined mounting surfaces for a consistent fit against the hull and pump assembly
• Corrosion-resistant construction suited to regular in-water use
• Designed as a direct replacement for the 2008 to 2010 Yamaha 212 SS 1100 bearing housing position
• Withstands the thrust and vibration loads of jet pump operation

Fits These Machines

• for Yamaha 212 SS 1100, 2008
• for Yamaha 212 SS 1100, 2009
• for Yamaha 212 SS 1100, 2010

On-The-Job Use

• Driveline rebuilds and pump service on Yamaha 212 SS 1100 boats
• Replacing a worn or damaged bearing housing after bearing failure
• Routine maintenance of the jet pump shaft assembly

Specs At A Glance

Good To Know

Q: What does a bearing housing do on a jet boat? A: It holds the pump shaft bearing in place so the shaft stays aligned under load. A worn housing can cause vibration, noise, or premature bearing failure.

Q: Will this fit any year of the Yamaha 212 SS 1100? A: This listing covers the 2008 through 2010 model years. Check your hull and serial number before ordering to confirm the housing matches your unit.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.