Bearing Housing for Yamaha 212 X 1100 2008-2010

Bearing Housing for Yamaha

This bearing housing is a replacement driveline component that supports and aligns the bearing assembly on Yamaha 212 X 1100 watercraft. It holds the bearing steady so the driveshaft runs true, and it is aimed at owners handling jet pump or driveline service themselves.

Overview

This bearing housing is made as a direct-fit replacement for the Yamaha 212 X 1100, giving the intermediate bearing a solid mounting point in the hull. The bearing housing keeps the bearing positioned so the driveshaft spins smoothly rather than wandering under load. It suits riders servicing a 2008 to 2010 Yamaha 212 X 1100.

Built For Performance

• Rugged cast construction sized for the intermediate bearing seat
• Machined bore to keep the bearing aligned with the driveshaft
• Mounting points matched to the Yamaha 212 X 1100 hull layout
• Resists corrosion from bilge water and regular engine bay exposure
• Retains the bearing firmly to reduce vibration through the driveline

Fits These Machines

• for Yamaha 212 X 1100, 2008
• for Yamaha 212 X 1100, 2009
• for Yamaha 212 X 1100, 2010

On-The-Job Use

• Driveline and intermediate bearing service on the 212 X 1100
• Replacing a cracked or corroded bearing housing
• Pump and shaft repairs after water intrusion or overheating
• Preventive maintenance on higher-hour jet boats

Specs At A Glance

Good To Know

Q: Do I need to replace the bearing too? A: It is worth inspecting the bearing and seals while the housing is off, since worn parts often travel together. If the bearing shows play or noise, replace it at the same time.

Q: Is this a direct fit for my boat? A: This bearing housing is listed for the 2008 to 2010 Yamaha 212 X 1100. Confirm your model year and serial number before ordering to be sure of the fit.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.