Bearing Housing for Yamaha 232 LTD 1100 2008-2009

Bearing Housing for Yamaha

This bearing housing is a replacement driveline component that supports and aligns the bearing assembly on Yamaha 232 LTD 1100 watercraft. It keeps the shaft running true so the pump and engine stay connected under load, and it is intended for owners performing routine jet pump or driveline service.

Overview

This bearing housing is built as a direct-fit replacement for the Yamaha 232 LTD 1100, giving the intermediate bearing a stable mounting point inside the hull. The bearing housing holds the bearing in position so the driveshaft turns smoothly instead of wandering under load. It suits riders servicing the driveline of a 2008 to 2009 Yamaha 232 LTD 1100.

Built For Performance

• Rugged cast construction sized for the intermediate bearing seat
• Machined bore to keep the bearing aligned with the driveshaft
• Mounting points matched to the Yamaha 232 LTD 1100 hull layout
• Resists corrosion from bilge water and regular engine bay exposure
• Retains the bearing firmly to reduce vibration through the driveline

Fits These Machines

• for Yamaha 232 LTD 1100, 2008
• for Yamaha 232 LTD 1100, 2009

On-The-Job Use

• Driveline and intermediate bearing service on the 232 LTD 1100
• Replacing a cracked or corroded bearing housing
• Pump and shaft repairs after water intrusion or overheating
• Preventive maintenance on higher-hour jet boats

Specs At A Glance

Good To Know

Q: Do I need to replace the bearing too? A: It is worth inspecting the bearing and seals while the housing is off, since worn parts often travel together. If the bearing shows play or noise, replace it at the same time.

Q: Is this a direct fit for my boat? A: This bearing housing is listed for the 2008 to 2009 Yamaha 232 LTD 1100. Confirm your model year and serial number before ordering to be sure of the fit.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.