Bearing Housing for Yamaha FX HO 1100 2004-2008 WaveRunner

Bearing Housing for Yamaha FX HO 1100

This bearing housing supports the driveshaft bearing assembly on the Yamaha FX HO 1100, keeping the shaft aligned and protected from water intrusion.

Overview

The bearing housing is a critical driveline component for the Yamaha FX HO 1100, holding the bearing that supports the driveshaft as it turns. This bearing housing for Yamaha FX HO 1100 helps maintain proper shaft alignment and shields the bearing from water and debris. It is intended for riders replacing a worn or corroded housing on their personal watercraft.

Built For Performance

• Houses the driveshaft bearing to keep the shaft properly supported
• Rugged construction suited to marine environments
• Helps protect the bearing from water and debris intrusion
• Designed as a direct replacement for the OEM housing location
• Maintains shaft alignment to reduce vibration

Fits These Machines

• for Yamaha FX HO 1100 (2004-2008)

On-The-Job Use

• Driveline repair on the Yamaha FX HO 1100
• Replacing a corroded or worn bearing housing
• Routine maintenance of the driveshaft bearing assembly
• Restoring proper shaft support after bearing failure

Specs At A Glance

Good To Know

Q: What does a bearing housing do on a Yamaha FX HO 1100? A: It holds the driveshaft bearing in place and keeps the shaft aligned while protecting the bearing from water. A worn housing can cause vibration or premature bearing failure.

Q: Should I replace the bearing when I change the housing? A: It is wise to inspect the bearing and replace it if worn or rough while the housing is off. Reusing a damaged bearing can shorten the life of the new housing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.