Bearing Housing for Yamaha FX1 700 1994 WaveRunner

Bearing Housing for Yamaha FX1 700

This bearing housing supports the driveshaft bearing assembly on the Yamaha FX1 700, keeping the shaft aligned and protected from water intrusion.

Overview

The bearing housing is a critical driveline component for the Yamaha FX1 700, holding the bearing that supports the driveshaft as it turns. This bearing housing for Yamaha FX1 700 helps maintain proper shaft alignment and shields the bearing from water and debris. It is intended for riders replacing a worn or corroded housing on their personal watercraft.

Built For Performance

• Houses the driveshaft bearing to keep the shaft properly supported
• Rugged construction suited to marine environments
• Helps protect the bearing from water and debris intrusion
• Designed as a direct replacement for the OEM housing location
• Maintains shaft alignment to reduce vibration

Fits These Machines

• for Yamaha FX1 700
• for Yamaha FX1 (1994)

On-The-Job Use

• Driveline repair on the Yamaha FX1 700
• Replacing a corroded or worn bearing housing
• Routine maintenance of the driveshaft bearing assembly
• Restoring proper shaft support after bearing failure

Specs At A Glance

Good To Know

Q: What does a bearing housing do on a Yamaha FX1 700? A: It holds the driveshaft bearing in place and keeps the shaft aligned while protecting the bearing from water. A worn housing can cause vibration or premature bearing failure.

Q: Should I replace the bearing when I change the housing? A: It is wise to inspect the bearing and replace it if worn or rough while the housing is off. Reusing a damaged bearing can shorten the life of the new housing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.