Bearing Housing for Yamaha GP 1200 1997 WaveRunner

Bearing Housing for Yamaha

This bearing housing is a replacement driveline component that supports and aligns the driveshaft bearing on Yamaha GP 1200 personal watercraft, giving the shaft a stable mounting point inside the hull.

Overview

This bearing housing is built to hold the driveshaft bearing securely in place on Yamaha GP 1200 models from 1997. As a replacement bearing housing, it keeps the shaft aligned so the pump and engine coupler run true under load. It suits riders and shops rebuilding a driveline or replacing a worn housing on a Yamaha GP 1200.

Built For Performance

• Machined housing bore sized for the driveshaft bearing
• Mounting flange drilled to match the factory bolt pattern
• Rigid cast body that resists flex under shaft load
• Sealing surfaces ready for grease retention
• Direct replacement for the original housing position

Fits These Machines

• for Yamaha GP 1200 1997

On-The-Job Use

• Driveline rebuilds on Yamaha GP 1200 hulls
• Replacing a cracked or worn bearing housing
• Routine shaft and bearing service
• Shop repairs before a season of riding

Specs At A Glance

Good To Know

Q: Will this bearing housing fit my 1997 Yamaha GP 1200? A: It is listed for the Yamaha GP 1200 in 1997, so check your hull year and serial before ordering. A: Verify the bearing size and bolt pattern against your existing housing first.

Q: Does the bearing come with the housing? A: This listing covers the housing itself unless otherwise stated, so reuse or replace the bearing as needed. A: Inspect the bearing and seals during installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.