Bearing Housing for Yamaha LX 210 1200 2003-2005

Bearing Housing for Yamaha

This bearing housing is a replacement driveline component that supports and protects the bearings in your jet pump assembly, keeping the shaft aligned and running smooth.

Overview

This bearing housing is a direct replacement part made for Yamaha personal watercraft, designed to hold the pump bearings securely in place so the driveshaft turns true under load. It is built for riders and mechanics who need to replace a worn or corroded housing without paying original equipment prices. The bearing housing fits specific Yamaha 1200 engine boats and is an ideal fix for noisy, rough-running jet drives.

Built For Performance

• Machined housing body sized to accept the correct pump bearing
• Corrosion-resistant construction suited to constant water contact
• Maintains correct bearing alignment to reduce vibration
• Sealed fit helps keep water and debris out of the bearing cavity
• Direct bolt-on replacement for the factory housing

Fits These Machines

• for Yamaha LX 210 1200 (2003-2005)

On-The-Job Use

• Replacing a worn bearing housing during jet pump service
• Restoring smooth driveline operation on a high-hours craft
• Freshwater and saltwater jet boat maintenance
• Routine inspection and rebuild of the pump assembly

Specs At A Glance

Good To Know

Q: Is this an original Yamaha part? A: No, this is an aftermarket bearing housing designed to fit Yamaha applications. Always confirm your model and year before ordering.

Q: Do I need to replace the bearings too? A: If the housing shows wear or corrosion, inspecting and replacing the bearings at the same time is a smart move. A complete pump rebuild saves you from pulling it apart again.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.