Bearing Housing for Yamaha VX Cruiser 1100 2010-2015

Bearing Housing for Yamaha VX Cruiser 1100

This bearing housing is a replacement component that supports and aligns the driveshaft bearing on Yamaha VX Cruiser 1100 personal watercraft, keeping the shaft centered and reducing wear on the pump and driveline.

Overview

This bearing housing is made to support the driveshaft bearing on Yamaha VX Cruiser 1100 watercraft from the 2010 through 2015 model years. A solid bearing housing holds the shaft in proper alignment, cuts vibration, and helps extend the life of the surrounding pump parts. It is aimed at owners servicing or rebuilding the driveline on a VX Cruiser 1100.

Built For Performance

• Machined to seat the driveshaft bearing accurately
• Rigid body limits flex during hard acceleration
• Corrosion-resistant finish for regular water contact
• Matches the stock mounting position for direct replacement
• Sealed mounting points that help block water and debris

Fits These Machines

• for Yamaha VX Cruiser 1100, 2010-2015

On-The-Job Use

• Driveline maintenance on VX Cruiser 1100 watercraft
• Rebuilding the shaft and pump assembly after wear
• Replacing a corroded or damaged factory bearing housing
• Pre-season servicing before summer riding

Specs At A Glance

Good To Know

Q: Will this fit every 2010-2015 VX Cruiser 1100? A: It is listed for that model and year range, but Yamaha can revise parts during a production run, so check your serial number before ordering.

Q: Is installation straightforward? A: Swapping a bearing housing means pulling the pump and driveshaft, so some mechanical experience and the right tools are recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.