Bearing Housing for Yamaha Wave Raider 760 1996

Bearing Housing for Yamaha Wave Raider 760

This bearing housing is a replacement driveline component for the Yamaha Wave Raider 760, built to hold the driveshaft bearing in place and keep the shaft turning smoothly.

Overview

This bearing housing serves as a direct-fit replacement for the Yamaha Wave Raider 760, supporting the driveshaft bearing inside the hull. It maintains shaft alignment to reduce vibration and protect the pump from excess load. Suited to owners and shops servicing 1996 Wave Raider 760 watercraft.

Built For Performance

• Housing bore sized for the driveshaft bearing used on the Wave Raider 760
• Sturdy build resists flex during hard acceleration and rough water
• Mounting holes line up with the factory bolt locations
• Clean sealing face for a snug fit against the hull tunnel
• Replaces a cracked or corroded housing that lets the shaft wobble

Fits These Machines

• for Yamaha Wave Raider 760 1996

On-The-Job Use

• Driveline repair on 1996 Wave Raider 760 watercraft
• Replacing a housing worn out by bearing failure or water exposure
• Pump and shaft service at home or in a repair shop

Specs At A Glance

Good To Know

Q: Should the bearing be swapped out at the same time? A: Check the driveshaft bearing while the housing is removed, because a worn bearing can ruin a fresh housing. Replacing both at once saves a second teardown.

Q: Does this fit other Yamaha models? A: This housing is listed for the 1996 Wave Raider 760. Verify your model and year before ordering, since bore and mounting sizes differ across engines.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.