Bearing Housing for Yamaha Wave Runner 760 1997-1998

Bearing Housing for Yamaha Wave Runner 760

This bearing housing is a replacement driveline component for the Yamaha Wave Runner 760, designed to hold and support the driveshaft bearing so it spins true under load.

Overview

This bearing housing is built as a direct-fit replacement for the Yamaha Wave Runner 760, seating the driveshaft bearing securely in the hull tunnel. It keeps the shaft aligned so vibration stays low and the pump receives steady power. A solid choice for riders and shops servicing 1997 to 1998 Wave Runner 760 models.

Built For Performance

• Machined housing bore sized for the driveshaft bearing used on the Wave Runner 760
• Rigid construction resists flex under repeated acceleration and chop
• Bolt pattern matches the factory mounting points for a straightforward install
• Sealing surface supports a clean fit against the hull tunnel
• Replaces a worn or corroded housing that causes shaft wobble

Fits These Machines

• for Yamaha Wave Runner 760 1997
• for Yamaha Wave Runner 760 1998

On-The-Job Use

• Driveline rebuilds on 1997 to 1998 Wave Runner 760 watercraft
• Replacing a housing damaged by water intrusion or bearing failure
• Routine pump and shaft service in a shop or home garage

Specs At A Glance

Good To Know

Q: Do I need to replace the bearing at the same time? A: It is wise to inspect the driveshaft bearing while the housing is off, since a worn bearing can damage a new housing. Replace both together if there is any play or roughness.

Q: Will this fit other Yamaha models? A: This housing is listed for the Wave Runner 760 from 1997 to 1998. Confirm your model and year before ordering, as mounting and bore sizes vary between engines.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.