Bearing Housing for Yamaha Wave Venture 1100 1997

Bearing Housing for Yamaha Wave Venture 1100

This bearing housing is a replacement driveline component for the 1997 Yamaha Wave Venture 1100, designed to support and align the driveshaft bearing so the jet pump spins true.

Overview

This bearing housing is built to replace a worn or corroded unit on a 1997 Yamaha Wave Venture 1100. It holds the driveshaft bearing in proper alignment, reducing vibration and keeping the jet pump turning smoothly. A solid bearing housing for the Wave Venture 1100 is the kind of part that quietly protects the whole driveline from damage.

Built For Performance

• Designed as a direct-fit replacement for the 1997 Yamaha Wave Venture 1100 driveline
• Rigid housing body keeps the driveshaft bearing seated and aligned
• Resists corrosion in the wet, high-vibration jet ski environment
• Helps reduce driveline noise and vibration under load
• Precision bore supports the bearing for consistent shaft rotation
• Lightweight construction keeps rotating mass in check

Fits These Machines

• for Yamaha Wave Venture 1100 (1997)

On-The-Job Use

• Routine driveline rebuilds on the 1997 Wave Venture 1100
• Replacing a pitted or worn bearing housing during pump service
• Restoring smooth driveshaft rotation after bearing failure
• Preventive maintenance on older Wave Venture 1100 skis

Specs At A Glance

Good To Know

Q: Does this bearing housing come with the bearing installed? A: This listing covers the bearing housing only, so check your existing bearing and seals and replace them as needed during the job. Q: Will this fit every Wave Venture 1100? A: It is listed for the 1997 Wave Venture 1100, so confirm your model year and serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.