Bearing Housing Repair Kit for Kawasaki Ultra 150 1200 1999-2005
Bearing Housing Repair Kit for Kawasaki Ultra 150 1200 1999-2005
Couldn't load pickup availability
Bearing Housing Repair Kit for Kawasaki Ultra 150 1200
This bearing housing repair kit is a complete rebuild solution for the jet pump bearing assembly on the Kawasaki Ultra 150 1200, giving the drive shaft the fresh bearings and seals it needs to spin smoothly again.
Overview
This bearing housing repair kit for Kawasaki Ultra 150 1200 watercraft is assembled to replace worn bearings and seals inside the pump housing. It restores smooth shaft rotation on 1999 to 2005 models and is aimed at riders and mechanics doing their own jet pump service. Every bearing housing repair kit here delivers the wear parts most commonly consumed during a pump rebuild.
Built For Performance
- Direct replacement for the pump bearing housing internals on the Ultra 150 1200
- Includes bearings, seals, and O-rings needed for a full housing rebuild
- Sealed bearing design keeps water and grit away from the rolling elements
- Heat and corrosion resistant materials suited to constant marine use
- Precision tolerances for a proper press fit into the housing bore
Fits These Machines
- for Kawasaki Ultra 150 1200, 1999
- for Kawasaki Ultra 150 1200, 2000
- for Kawasaki Ultra 150 1200, 2001
- for Kawasaki Ultra 150 1200, 2002
- for Kawasaki Ultra 150 1200, 2003
- for Kawasaki Ultra 150 1200, 2004
- for Kawasaki Ultra 150 1200, 2005
On-The-Job Use
- Routine jet pump rebuilds on the Ultra 150 1200
- Replacing noisy or rough bearings found during winter maintenance
- Restoring a pump pulled apart for impeller or wear ring service
- Preventive replacement before a rebuild turns into a full pump swap
Specs At A Glance
| Part Type | Bearing Housing Repair Kit |
| Compatible Brand | for Kawasaki |
| Compatible Model | Ultra 150 1200 |
| Model Years | 1999-2005 |
| Kit Contents | Bearings, seals, and O-rings for housing rebuild |
Good To Know
Q: Do I need any special tools to install this kit? A: A bearing press or driver set is normally required to seat the bearings and seals properly. Check your service manual for torque and press depth specs before starting.
Q: How often should the pump bearings be replaced? A: Many riders rebuild the bearing housing every couple of seasons or whenever roughness, noise, or water intrusion is noticed. Frequent shallow water use shortens the interval.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
